REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz M-Class (W163, 1997 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W163
		Introduction
		Controls and receptions of safe operation
		Current care and maintenance
		Engine
		System of cooling, heating and air conditioner
		The power supply system and exhaust
		Systems of an electric motor
			Ignition and engine control
				The basic data and security measures
				Checks control ignition and injection
				Troubleshooting - general information and preliminary checks
				Check and adjust the ignition timing
				Spark plug
				Removing and installing ignition coils, - petrol models
				Removal and installation of the crankshaft position sensor (CKP)
				Removal and installation of the camshaft position sensor (CMP), - the engine 111 series
				Removing and installing the camshaft Hall sensor - petrol engines series 112, 113 and 612 series diesel engines
				Removing and installing knock sensors (KS), - Petrol Engines
			System of preheat of the diesel engine
			Diagnostics of systems of electronic control and diagnostic equipment
			Charge and start systems
		Manual box of a gear change
		The transmission automatically processed
		Transmission Line
		Brakes and auxiliary systems
		Suspension and steering
		Body
		Onboard electric

printable version

Removing and installing knock sensors (KS), - Petrol Engines

Details of the sensor KS at 111 series engines are shown in the illustrations, - track reliability of fixing pin connector wiring.

Location sensor KS (A16 / 1) on the engine 111 series

Pin wiring sensor KS 111 series engine

M112 / 113

Details of the sensors KS Series 112 engines and 113

A16 / 2 - Left knock sensor (KS 2)

PERFORMANCE ORDER
Details of the sensors KS at engine series 112 and 113 are shown in the illustration, - track reliability of fixing pin connector wiring.
Remove the inlet pipeline (see chap. Engine).
Remove the corresponding sensor (right or left) of the cylinder.
Installation is in the reverse order.

« previos page
Removing and installing the camshaft Hall sensor - petrol engines series 112, 113 and 612 series diesel engines

next page »
System of preheat of the diesel engine