printable version

Replacing the front output shaft oil seal

Replacing the front output shaft oil seal

1 - Transfer Case 2 - Cover the crankcase 3 - Drain plug 4 - filler plug 5 - Bolts 6 - Bolts 7 - Speed sensor	8 - Output flange rear propeller shaft 9 - Seal 10 - Disc 11 - Nut 12 - Servo 010 - Mounting stand 020 - Supporting plate

Replacing the front output shaft oil seal

1 - Transfer Case 13 - sprocket 13a - The drive chain 14 - Retaining Ring 15 - Ball Bearing	16 - Front output shaft 17 - Seal 18 - Planetary gear 19 - The rear output shaft

Replacing the front output shaft oil seal

17 - Seal	030 - Mandrel

PERFORMANCE ORDER

Illustrative material on the replacement of the gland of the front output shaft transfer case is shown in the illustrations, which include all the links in the text. Remove the plug (3) and the drain of the transfer case oil. Remove the transfer case (1) (see. Section Removal and installation of a distributing box) and secure it to the mounting stand (010) with the base plate (020). Remove the rear output flange (8) (see. Section Replacing the gland outlet flange rear propeller shaft). Remove the screws (6) and remove the servo motor (12), complete with speed sensor (7). Pull out and remove the speed sensor (7). Remove the bolts (5) and remove the cover (2). Pull out, remove the sprocket (13), complete with a drive circuit (13a). Remove the retaining ring (14) and remove the output shaft of the front axle (16). When removing the locking ring hold the shaft stationary. Having hooked a suitable screwdriver, remove the gland (17) of the front output shaft of his landing nest and put on the new one, using a suitable mandrel (030), - to secure the gland zastukivaniem planetary gear assembly (18) to prevent it from falling out. Replace the front output shaft (16) and secure it with the retaining ring (14), having tracked reliability of landing of the latter in the receiving groove. Install the chain drive assembly (13 and 13a). Priboltite cover (2), preliminarily cleaning the mating surfaces, and put a suitable sealant. Replace the servo motor (12) and a speed sensor (7), tighten mounting bolts (6). Install the rear propeller shaft flange (see. Section Replacing the gland outlet flange rear propeller shaft). Fill the transfer case fresh oil up to the level of the lower cut filler / level plug. Finally, start the engine and check the transfer case for signs of leaks.