add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz M-Class (W163, 1997 issue)

general info. full specifications. diagnostics. hints. tips. tricks
Mercedes-Benz W163
Home
 
Mercedes-Benz
W163
Introduction
Controls and receptions of safe operation
Current care and maintenance
The active warning system Maturity planned TO (ASSYST)
The routine maintenance schedule
General information about the settings,
Check fluid level, leakage control
Checking the condition of tires and pressure in them, the designation of tires and wheel rims, wheel rotation
Replacing the motor oil and oil filter
Check the brake system
Check the power supply system, replacement of the fuel filter
Check and replacement of hoses of an impellent compartment, localization of leaks
Checking the multirebernyh accessory drive belt
Check the functioning of the cooling system and frost coolant fluid replacement
Checking the exhaust system
Replacement and check of level ATF, AT filter replacement
Visual check of tightness automatic transmission
Checking the suspension components and steering
Checking the status of anther drive shafts
Check the air conditioning system
Grease limiters door locks and cylinders
Visual inspection of safety belt and airbag unit
Verifying the headlights and horn
Check and replace wiper blades
Checking the status of the battery, care it and gymnastics
Replacing the cabin filter
Replacing brake fluid
Check and replacement of spark plugs, check the status of high-voltage wires (petrol models)
Engine
System of cooling, heating and air conditioner
The power supply system and exhaust
Systems of an electric motor
Manual box of a gear change
The transmission automatically processed
Transmission Line
Brakes and auxiliary systems
Suspension and steering
Body
Onboard electric
 


Hit Counter by Digits


print page printable version

Verifying the headlights and horn



PERFORMANCE ORDER

  1. Turn on the ignition and check the operation of all exterior lighting.
  2. With the help of an assistant or fit the car back up to a wall, test the stoplights. When you press the brake pedal should be lit only stoplights. Include all possible lighting, located in the rear block headlights (reversing signals, marker lights, and others.), And then click again on the brake pedal. When you turn on stoplights you find the failure of any of the other signals included, the reason for this may be an unreliable contact with the "weight" or bad contact in the lens unit.
  3. Now test head optics. Turn neighbor, then the main beam.
  4. Upon detection of blown bulbs, replace them, following the recommendations given in Chapter Onboard electric equipment.
  5. Check the operation of all vnutrisalonnoe lighting, including illuminated glovebox and luggage compartment. Turn on the ignition and make sure that all the warning lights are lit up. Chapter Controls and receptions of safe operation is described in detail which lamp should light up when the ignition. Start the engine. Warning lights must go out. Touring in the dark, then test all of the backlight (as the instrument cluster and dashboard). When a fault is detected, refer to the appropriate section in the Onboard electric equipment.
  6. Sometimes, the lamp can fail because of the appearance of them or cartridges rust. Replacing the lamp you do not get rid of the problem. Therefore, by replacing either of the lamps, carefully inspect the inside of the cartridge. When build-green or white remove them with sandpaper.
  7. Finally, test the horn.




« previos page
Visual inspection of safety belt and airbag unit
next page »
Check and replace wiper blades

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.