printable version

Removal and installation of antenna amplifiers

Power antenna radio / TV-tuner

Details of the amplifier antenna radio / TV-tuner

1 - Connector cable stuck on the glass antenna 2 - knurled nut 3 - Antenna cable	4 - Nuts A2 / 51 - Aerial amplifier H39 / 32 - Connector harness power

PERFORMANCE ORDER

On models corresponding complete set (code ET2) activate the service mode of the emergency call TELE AID (see. Section Activate / deactivate the service mode of the emergency call AID TELE). Disconnect the negative wire from the battery. Remove the ceiling upholstery (see chap. Body). Disconnect the connector (H39 / 32) harness power. Release knurled nut and disunite the antenna cable connector (3). Give fixing nuts (4) and remove the amplifier (A39 / 32) Antenna radio / TV-tuner Installation is in the reverse order - on the model of the corresponding configuration (code ET2) deactivate service mode of TELE AID (see. Section Activate / deactivate the service mode of the emergency call AID TELE). Finally, make the DTC reading and clearing of system memory on-board self-diagnostic scanner using STAR DIAGNOSIS (6511 1801 00) (see chap. Systems of an electric motor) and perform basic programming.

Power antenna IR receiver of the uniform lock

Details of the amplifier (A2 / 65) antenna IR receiver of the uniform lock

PERFORMANCE ORDER

Remove the instrument panel (see chap. Body). Remove from reaching the antenna module (A2 / 65) the signal wiring. Gently release the connecting wire antenna from its holder on the windshield. Disconnect the electrical wiring from the antenna amplifier (A2 / 65). Release fasteners, separate amplifier (A2 / 65) from the body panel and remove it from the vehicle. Installation is performed in reverse order - do not forget to replace sealing strip of foam rubber.