add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Micra (2002 model year)

general info. full specifications. diagnostics. hints. tips. tricks
Nissan Micra
Home
 
Nissan
Micra
Introduction
Controls and operation receptions
Options and car routine maintenance
Engine
The engine cooling system, heating, ventilation and air conditioning
The power supply system and exhaust
Systems of an electric motor
Manual box of a gear change and clutch
Automatic Transmission
Drive shafts, steering knuckles and Hub assembly
Brakes
Suspension and steering
Body
Outdoor equipment and body parts
Removing and installing fairing windshield
Removal and installation of decorative grille
Removing and installing moldings and seals
Removing and installing front bumper and front spoiler
Removing and installing rear bumper
Removal and installation of a forward wing and lockers
Removing and installing radiator support beams
Removal, installation and adjustment of the hood
Removing and installing hood locks and fuel filler flap
Removal, installation and adjustment of the tailgate and the components associated with it
Removal, installation and adjustment of the side doors
Removal and installation of locks and door handles
Removal, installation and adjustment of the top hatch assembly and its components
Removal, installation and repair of the door mirror
Salon Equipment
Onboard electric
Diagrams
 


Hit Counter by Digits


print page printable version

Removal, installation and adjustment of the tailgate and the components associated with it



Removal and installation of doors, racks and drummer of the castle

PERFORMANCE ORDER

  1. Remove the tailgate trim (see. Section Removing and installing door trim panels).
  2. Disconnect the inside door release the wiring from the clamps and pull it out of the door.
  1. Hold the tailgate, remove the screwdriver to upper bracket rack doors and remove the base from the hinge.
  1. If necessary, remove the rack, remove the screws securing it to the body.
  1. Remove the hinge bolts of the tailgate to the body and remove the door.
  1. If necessary, remove the screws and remove the firing pin tailgate, after removing the lower bar, removing the tailgate opening.
  1. Installation is in the reverse order. Finally, adjust the position of the door.

Removal and installation of the lock

PERFORMANCE ORDER

  1. When removing the trim panel of the tailgate disconnect the electrical door lock.
  1. Turn out bolts and remove assemblage of the lock from the inside of the door.
  1. Installation is in the reverse order. Finally, check and if necessary adjust the lock work.

Removal and installation of door handles and tailgate

PERFORMANCE ORDER

  1. Remove the tailgate trim.
  2. On models with the system ?�Intelligent Key?� remove the receiver, as well as the holders of its wiring and connectors to the tailgate.
  1. Give nuts and remove the handle.
  1. If necessary, remove the screws and disassemble the handle.
  1. Installation is in the reverse order.

Adjustment

PERFORMANCE ORDER

  1. Remove the bottom of the bar, removing opening the tailgate and loosen the screws that secure the striker tailgate.
  1. Moving the drummer, adjust the position of the tailgate in the opening according to the illustration. The difference Vecdi gaps B // C // D left and right, respectively, should not exceed 2 1.5 // // 2 mm.
  1. If the movement of the striker to achieve the correct position of the door is not possible, give nuts tailgate hinges on the body.
  1. After adjustment, tighten fixture with demanded effort.




« previos page
Removing and installing hood locks and fuel filler flap
next page »
Removal, installation and adjustment of the side doors

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.