printable version

Removing and installing radiator support beams

Top

Fastening the radiator support beams

PERFORMANCE ORDER

Remove the headlights (see chap. Onboard electric equipment). Remove the assembly, and the bonnet lock bracket (see. Section Removal and installation of the hood locks and fuel filler flap). Remove the upper radiator support beam wire-locks the bonnet air intake hose and clamps. 1 - Upper bar 2 - Sleeve 3 - Cable 4 - Duct 5 - Catches 6 - Cover 7 - Lock Remove the cover washer fluid reservoir and pull down the neck of the tank. Remove the boots and remove the top of the radiator support beam (see. Illustration Fasteners radiator support beams). Installation is in the reverse order.

Lower

PERFORMANCE ORDER

Remove the grille (see. Removing and installing decorative grille) and the tab on the top of the duct. 1 - Upper bar 2 - Sleeve 3 - Cable 4 - Duct 5 - Catches 6 - Cover 7 - Lock Remove the lower front bumper clips (see. Section Removal and installation of the front bumper and the front spoiler). Remove the screws, remove the clips and separate the cover from the bumper lockers (see. Section Removal and installation of the front bumper and the front spoiler). Fasten harnesses radiator and the condenser K / V on the upper radiator support beam. Remove the screws (see. Illustration Fasteners radiator support beams) and remove the bottom support beam. Remove the bottom of the duct clamps. Installation is in the reverse order.