 printable version
Removing and installing fuel tank
The components of the installation of the fuel tank and the filler neck  | | |
| - Remove the right wheel assembly and the fuel pump with the filter and the sensor. Do not remove the sensor.
- Remove the core and center mufflers and hangers.
- Move the parking brake cable to the bottom surface of the fuel tank and remove the cable clamps.
 | - Disconnect the water inlet hose from the fuel tank.
|
 | Do not disconnect the hose from the filler tube. If this is nevertheless necessary, apply a pipe and hose adjusting labels. |
 | - Remove the breather hose on the side of the right rear wheel arches, and EVAP hose to the front of the fuel tank. Put the open end of the fuel lines plastic bags.
|
- Prop up the center fuel tank jack, pre-paving between the wooden block.
- Remove the bandage tapes of fastening of a fuel tank.
- Gently lower the jack pot, hand holding tank. At the same time pull the breather hose through the hole in the back of his hand and pulling the parking brake cable.
- Installation is in the reverse order. Place the banding in accordance with labels ?�R?� (right) and ?�L?� (left) to them.
- After installation, check the power supply system for leaks (see. Chapter Settings and maintenance of the car).
|
|
|
