printable version

Anti-roll bar

Fastening the stabilizer bar in the rear suspension

1 - connecting rod 2 - a nut, 42 - 48 N ??? m 3 - a bolt, 32 - 43 N ??? m 4 - mounting bracket 5 - grommet 6 - a nut, 32 - 43 N ??? m 7 - mounting bracket	8 - a bolt, 32 - 43 N ??? m 9 - Rod stabilizer 10 - mounting bracket 11 - a bolt 12 - a bolt 13 - a nut

Removing and installing stabilizer bar can be made on the basis of the above illustration. The stabilizer is fixed to the attachment strut through the connecting rods with two ball fingers, and on the bottom clamps and rubber grommets. To get to all the fixtures, set the rear of the car on supports.

When removing Observe the rubber plugs. They have a slot that after installation should be facing up. Before tightening the nuts of ball joints connecting rods, hinges to align at a right angle to the bar. Only in this position, tighten the nut with a force of 42 - 48 N ??? m. Lower the car on the earth and tighten bolts under load both mounting clamps.