printable version
Distributor installation
If after removing the distributor of the crankshaft position is not compromised 1. Turn the slider to the position indicated by the distributor before removal. 2. Install the valve slightly provernuv run knock to the groove on the rail engages with the drive roller 3. If the position of the body relative to the distributor block has not changed, and the mounting holes are aligned. then labeling the runner and the housing of the distributor should be located opposite each other. 4. Tighten the bolts with the set moment. 5. Replace the cover and connect the wires. 6. Check the ignition. If after removing the distributor position of the crankshaft was broken 7. Set the piston of cylinder 1 to TDC of the compression stroke. 8. Replace the valve cover. Identify the place where is located the output wire of 1st cylinder g mark label on the distributor case. 9. Remove the cover, turn the slider, placing it in front of the label. 10. Replace the cover and connect the wires 11. Check the ignition.
|