printable version
The fuel injection system - Adjustment pre-injection (TBI)
Check and adjust high idle speed 1. Warm up the engine. 2. Make sure that the installation mark is opposite the cam roller thrust cam. Otherwise, adjust by turning the screw S1. If you can not handle, replace the fuser (photo). 3. Check the gap G between the roller and the cam rod (photo). If necessary, adjust the gap by turning the screw S2. Proof of idling air conditioner (FICD System) check and adjustment 4. Warm up the engine. 5. Check idle speed.
| 14.3 Adjusting the high idle speed on the case flap 1. Fuser 2. Heater housing 3. The gap G 4. Throttle lever 5. Adjusting screw Adjusting screw S2 6. Throttle 7. Remove the cap 8. Link ku |
6. Turn on the air conditioner and check the idle speed. 7. If necessary, adjust the rotation of the screw (see photo). 8. In the event of failure of the valve equalizer idling, check the following (photo). a). Disconnect 8shtyrkovy connector. | 14.7 Adjusting the idle speed when the air conditioner 1. Adjusting screw 2. Valve corrector idling |
b). Turn on the ignition, turn the air conditioner in the operation and check the voltage across the terminals of the connector (photo) at). Check the integrity of the valve coil. Pnevmoamortizator check and adjustment 10. Warm up the engine. Check the idle speed, adjust if necessary. 11. Turn the valve by hand so that the rod touched pnevmoamortizatora stroke adjusting screw and check the engine speed (photo). 12. If necessary, adjust the rotation speed of the adjusting screw. | 14.8 Checking the equalizer valve on the engine V6 (A) and 4-cylinder engine (B) A 1.4. Valve corrector 2J3. Ignition conditioner 5. Check valve coil circuit B. Earth connection voltage 7. Verification B 1. Valve corrector |
| 14.11 Adjusting pnevmoamortizatora 1. Adjusting screw 2. pnevmoamortizatora Pnevmoamortizator 3. Adjusting screw throttle |
| 14.13 Checking valve higher idle speed the engine V6 (A) and 4-cylinder engine (B) A 1.3. The valve 2. Check valve coil circuit in 1 valve |
| 14.17 Label Q must be opposite the roller 1. Roller |
| 14.18 cam adjustment screw (A) and locknut |
| 14.19a Gap G between the roller and cam roller 1. 2. Cam |
Check valve increased idle speed 13. Disconnect 8shtyrkovy connector (photo) and check valve coil circuit. 14. If a break is detected, replace the valve. The new valve & tighten the set moment, replacing the gasket The direct injection The system increased idle speed check and adjustment (engine K24J) 15. Warm up the engine. 16. Stop the engine and remove the air filter. 17. Make sure that the adjusting label (Q) is located opposite the roller {photo). 18. Adjust the cam by turning the screw until the upper edge of the cam is not in alignment with the center of the roll (see photo). 19. Check the gap G between the roller and cam (photo). If necessary, adjust the gap by turning the screw B.
| 14,196 Adjustment throttle 1. 2. Roller Thrust 3. Screw 4. In This label is designed for a different purpose (not to adjust) 5. Cam |
|