printable version
The inner door panel - removal and installation
1. Lower the window. 2. Remove the screws that secure the armrest to the panel. 3. Remove the window handle for which a thin curved instrument remove the snap ring. To do this, press the decorative cover to gain access to the shaft and a spring ring, hook ring and slide in the direction of the handle, and remove the ring. Remove the handle and the plastic washer.
| 14.5 To remove the flap handle, unscrew one screw |
4. Remove the handle of the door lock. 5. Remove the decorative panel door handles (photo). 6. Pry the screwdriver and remove the panel latch from the door frame (see photo). Get latch start from the bottom and moves up, removing the latches on the circuit panel. Lift and remove the panel. 7. Before installation, check the status of all of .. lock and ensure the correct orientation of the water filter. 8. Install the panel, guided by the inserted; koyatke window.
| 14.6 Latch mounting inner door panel |
| 15.7 Details of the door and window 1. Adjusting the doors 2. Adjust the position of the hinge 3. Adjust the front gutter 4. Adjustment of the mechanism window 5. Tilt the glass to window regulator 6. Adjust the Lock
|
9. Insert the tabs into the holes of the door frame (by hand or with a plastic hammer). 10. Further installation is performed in reverse order. Fix the window handle of a spring ring. To do this, insert the snap ring in the groove on the handle so that the gap of the ring was turned by 180 ?� from the handle, set parallel to the handle grip on the opposite door and push the ring until it clicks.
|