1. To disconnect a wire from "the minus" plug of the storage battery. |
2. Unscrew the two screws 19 (see. Fig. Details generator company Bosch). |
3. Remove the voltage regulator 18 to the brush holder. |
4. Measure the distance A (see. Fig. Voltage regulator with brush holder) from the end of the brush holder to the edge of the brush (ie, how are the brush from the brush holder), which shall be under the new brushes 13 mm, the minimum distance - 5 mm. |
5. If the distance A is less than 5 mm, it is necessary to replace the voltage regulator with the brush holder (if required replacement of brushes). |
6. Check it easy to move the brush into the brush holder. |
7. Install the regulator voltage generator. |
8. Tighten the screws. |
9. Attach a wire to "the minus" plug of the storage battery. |