printable version
Interior decoration of the front door
Removal in the following order:
| Fig. 16.23a. Interior decoration of the front door in the early models: 1 - waterproofing protective film; 2 - a nut; 3 - Bracket; 4 - the handle to close the door from the inside; 5 - lining the inside door handle; 6 - a decorative plate; 7 - decorative panel; 8 - lock button door lock; 9 - bracket lock button (pressed inward); 10 - lock bezel
|
- Remove the trim panel; - Remove the decorative plate (attached to snap indentation);
| Fig. 16.24. Removal of the handle window: 1 - pad; angle a = 45 (?� 12) ?�
|
- Door with windows with manual transmission, remove the cover in the direction of the arrow with the window handle, unscrew the mounting screw and remove the handle (Fig. 16.24); - Remove the spacer ;. - Carefully remove the trim on the inside door handle closing and then unscrew the two screws and remove the handle;
| Fig. 16.25. Removing the lining of the internal handle
|
- Remove the trim cover of the internal handle of opening the doors, which gently pull the stick back, hook the cover and slide it to the back of the door (Fig. 16.25); - Remove the lever outside mirror; - Remove the screw securing the inner door trim, remove the interior trim of the window slot seal, then lift and remove it from the door;
| Fig. 16.23b. Interior decoration of the front door on later models: 1 - plug and tweeter; 2 - a decorative overlay of the internal handle; 3 - the handle; 4, 5, 7, 12 - screw; 6 - a decorative overlay; 8 - lock button door lock; 9 - bracket lock button; 10 - bracket; 11 - bracket; 13 - decorative panel; 14 - Rubber finish; 15 - pocket; 16 - speaker grille; 17 - the handle of window
|
- Unscrewing the fixing screws, remove the pocket 15 (see. Fig. 16.23b) door; - If necessary, disconnect the wire from the speaker; - To remove the protective film, remove the compressed water isolating the pins and remove the staples; - Remove the remote control door lock and remove the lock rod; - Gently unscrew and remove the doors protective waterproofing film. Installation spend to sequences, return to removal. Replace broken when removing the staples. Check the connection of the electrical connectors. When installing the window handle is necessary to sustain its position in accordance with Fig. 16.24 (angle "a" should be 45 ?� ?� 12 ?�), wherein the window has to be closed completely.
|