 printable version
Refitting
Removal in the following order: - Disconnect "minus" wire from the battery terminals; - Remove the steering wheel.
Early models
| Fig. 16.62. Screws (indicated by arrows) securing the pad instrument cluster: a - the early models; b - on later models
|
Removing the two screws, remove the trim of the instrument cluster (Fig. 16.62); - Unscrew the screws and remove the instrument cluster.
Later models Remove the three ventilation grille on the driver side and in the center; - Remove the rotary light switch; - Remove the trim behind the left side of the steering wheel; - Remove the four screws - one behind each ventilation grills and one behind the trim - trim and remove the instrument cluster (Fig. 16.62, a);
All models
| Fig. 16.63. Two screws (2) securing the cover to the body of the instrument cluster and the two screws (1) securing the instrument cluster assembly
|
Rotate the screws, carefully remove the speedometer cable, connectors, wiring, if necessary, disconnect the vacuum hose from the multi-function display and remove the instrument cluster (Fig. 16.63);
| Fig. 16.64. Removing and installing devices with a combination of devices on cars early lineup: 1 - fuel gauge; 2 - speedometer; 3 - tachometer; 4 - pin; 5 - the screw fastening
|
- Remove the devices on cars of earlier models, as shown in Fig. 16.64. To remove the fuel gauge pointer 1 and 3 tachometer remove pins 4. Remove the pointer by disconnecting it from the connector housing and the printed circuit board. to remove the speedometer 2 Remove the screw securing 5;
| Fig. 16.65. Removing and installing devices with a combination of devices in cars later models: 1 - fuel gauge and coolant temperature; 2 - speedometer; 3 - tachometer; 4 - the screw
|
- Remove the devices in cars later models, as shown in Fig. 16.65. To remove a pointer 1 fuel level and coolant temperature or tachometer 3, you need to carefully remove them from the connector housing and the printed circuit board. To remove the mechanical speedometer Remove the screws 4 and carefully remove the speedometer 2 from the case. To remove the electronic speedometer with odometer must be careful to get it out of the housing and remove the pin. Devices can be removed without removing the body of the instrument cluster.
| Fig. 16.66. Details speedometer cable: 1 - spring housing; 2 - wire; 3 - seal
|
Speedometer cable connection is performed in accordance with Fig. 16.66. The cable is introduced into the rear side of the speedometer. Fixing the speedometer cable is provided by a spring mounted in a cable cover. Install dash spend to sequences, return to removal.
| 
