 printable version
Rear-wheel drive vehicle suspension (Syncro)
| Fig. 10.35. Rear-wheel drive vehicle suspension (Syncro): 1 - an arm of the suspension gear case; 2 - gear; 3 - the drive shaft; 4 - spring struts; 5 - arm rear suspension; 6 - fixing support beams; 7 - bar; 8 - anti-roll bar; 9 - propeller shaft
|
Rear-wheel drive vehicle suspension (Syncro) is shown in Fig. 10.35.
The corners of the rear axle all-wheel drive car (Syncro)
| Fig. 10.36. Eccentric bush for adjusting the angle of the rear axle
|
Corners of installation of the rear wheels are controlled by silent-blocks with eccentric bushing (Fig. 10.36). The collapse of the rear wheels .................. 1 ?� 25 '?� 30' The convergence of the rear wheels .......... 0 ?� 15 '?� 20'
Adjustment of corners The adjustment is made in the following order: - Turn up the eccentric bushing with a negative camber angle; - Turn down the eccentric bushing with a positive camber angle; - Turn the eccentric bushing with the forward toe; - Turn the eccentric bushing with a negative convergence ago.
Replacement airbag suspension rear axle gear case Remove the support suspension rear axle housing. Extract the suspension of a support pillow.
Replacing the silent blocks securing the support beams Replace in the following order: - Remove the mounting support beams from the vehicle; - Establish a chisel between the Hob and the support; - Pull with a lever vkaladysh Hob; - Tweezers, remove the other liner;
| Fig. 10.37. Installation inserts Hob beam
|
- Insert a new Hob set at an angle of 40 ?� relative to the longitudinal axis of the vehicle with the device 3084 (Fig. 10.37); - Establish a support on the car and check the wheel alignment.
| 
