printable version
Replacement seals crankshaft
Replacement of a forward epiploon of a cranked shaft in the following order: - Remove the timing belt (see. Sect. 3.1.4) and toothed crankshaft pulley;
| Fig. 3.27. The cylinder block, crankshaft and intermediate shaft: 1 - bolts of main bearing cap of the crankshaft; 2 - a cover of the crankshaft bearing; 3 - insert crankshaft bearing; 4, 6 - persistent half rings; 5 - insert the central (axial) crankshaft bearing; 7 - crankshaft; 8 - a bolt of fastening of a cover of the intermediate shaft; 9 - gland intermediate shaft; 10 - a cover of the intermediate shaft; 11 - O-ring cover the intermediate shaft; 12 - an intermediate shaft; 13 - front oil seal of the crankshaft; 14 - bolts of the front cover of the crankshaft; 15 - The front cover of the crankshaft; 16 - a lining of the front cover of the crankshaft; 17 - the block of cylinders
|
- Remove the bolts 14 (see. Fig. 3.27) that secure the front cover of the crankshaft, oil pan mounting bolts to the lid, remove the lid 15 and gasket 16; - Remove the front oil seal of the crankshaft 13 from the cover 15; - Thoroughly clean the surface of the opening cover 15 to install the gland; - Dip 13 new oil seal into the engine oil and insert it into the cover 15 with a mandrel. Make sure that the working edge of the gland is directed inwards; - Install the front cover 15 Gland cylinder block and tighten the screws 14 alternately crosswise; - Establish a gear crankshaft pulley and timing belt. Replacing the crankshaft rear oil seal in the following sequence: - Remove the flywheel or the drive plate (see. Sect. 3.1.8); - Unscrew the back cover of the crankshaft, remove the cover and cover gasket; - Remove the crankshaft rear oil seal from the rear cover; - Thoroughly clean the surface of the opening of the lid seal installer; - Dip the new seal into the engine oil and insert it into the cover with the mandrel. Make sure that the working edge of the gland is directed inwards; - Replace the back cover from the gland to the cylinder block and tighten alternately cross-wise; - Install the flywheel or the drive plate.
|