printable version
Fog lights
| Fig. 337. Mounting bolts fog
|
Fog lights are installed in the bumper under the headlights. The procedure for its removal depends on the performance of the bumper. If small bumper, remove the decorative cap on the bottom side and loosen the screws indicated by arrows in Fig. 337. Take out the lights from the bumper and disconnect the electrical connector on the back side.
| Fig. 338. Bolts fog in a car with a large bumper 1 - a decorative cladding
|
By car bumper with a large disconnect the decorative trim (Fig. 338) from the spring clips and remove the bolts indicated by arrows. Remove the headlight and disconnect the electrical connector on the back side. Setting range of both modifications carried out in the reverse order of removal. Fog lights can be adjusted, it is best to do so in the service station. The light beam range can be adjusted only in the vertical plane.
| Fig. 339. fog lamp with the cover removed: 1 - an electric socket; 2 - a spring clip
|
To replace the lamp, turn the fog light to the left and remove the cover on the back of the headlight. On the inside cover, disconnect the electrical connector 1 (Fig. 339) from the contact tab. 2 Squeeze the spring clip in the spotlight over the tabs and remove the bulb (H3, 55W) of the headlights. Do not touch the lamp bulb. Installing the lamp is held in reverse order. The projection lamp socket to be coaxial with the guide in the lamp housing.
|