add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Sharan (from 1995 to 2000, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Sharan
Home
 
Volkswagen
Sharan
Introduction
VR6 engine
The two-liter engine (ADY)
Engine oil
Cooling
A fuel injection system VR6 engine
Precautions during repair work on the injection system
The principle of ECM under different conditions
Injection system
Fault injection system
Carrying out repairs and maintenance of injection
The accelerator cable
The electric fuel pump
Fuel filter
The fuel level sensor in the tank
Air filter
The system Simos injection 2.0-liter engine
The ignition system
Coupling
Manual 5-speed gearbox
The drive shafts
Power steering
Front suspension
Rear suspension
Brakes
Electrical
Diesel engine
The lubrication system of the diesel engine
The cooling system of the diesel engine
The power supply system of the diesel engine and turbocharger
Map service.
Applications
Wiring
 


Hit Counter by Digits


print page printable version

Precautions during repair work on the injection system



When carrying out repairs and maintenance of the injection to avoid injury or damage to the system itself, take the following precautions:
A warning
To prevent damage from electrostatic discharge, it does not disassemble the metal casing of the computer and touch the connector pins.

A warning
People with a pacemaker are prohibited to carry out repairs to the power system and related system of ignition engine.

- Never touch the electric wires when the engine is running or is turned starter;
- Disconnect and connect the electrical wires of the injection and ignition only when the ignition is off. After turning off the ignition, wait at least 20 seconds in order to cool the thread air flow sensor;

Disabling receipt of electric current in the ignition system
Fig. 199. Disabling receipt of electric current in the ignition system





- While cranking the engine to engine start has not occurred, you should disable the flow of electric current in the ignition system. To do this, disconnect all pyatishtyrkovy the plug connector of the ignition coil (Fig. 199);
- Start the engine by the "Booster" from another vehicle should last no more than 1 minute at a voltage of less than 16.5;
- When washing the engine ignition must be turned off;
- Before performing welding operations necessary to disconnect the wires from the battery and the plug connector from the ECU;
- Must not be interrupted by AB-board network with the engine running;
- Charging AB must be disconnected from the electrical system;
- Not be exposed to temperatures above the ECU 85 ?� C, such as temperatures of the drying chamber. In this case the computer must first be dismantled;
- It is necessary to control the reliability of contacts, the wiring harness and support the full purity of the terminals AB;
- Are not allowed disconnection and connection of the plug blocks the computer with the ignition on;
- When towing the vehicle, to avoid damage from the ignition system, always disconnect the plug connector from the ECU.




« previos page
A fuel injection system VR6 engine
next page »
The principle of ECM under different conditions

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.