add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Sharan (from 1995 to 2000, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Sharan
Home
 
Volkswagen
Sharan
Introduction
VR6 engine
The two-liter engine (ADY)
Engine oil
Cooling
A fuel injection system VR6 engine
Precautions during repair work on the injection system
The principle of ECM under different conditions
Injection system
Fault injection system
Carrying out repairs and maintenance of injection
The accelerator cable
The electric fuel pump
Fuel filter
The fuel level sensor in the tank
Air filter
The system Simos injection 2.0-liter engine
The ignition system
Coupling
Manual 5-speed gearbox
The drive shafts
Power steering
Front suspension
Rear suspension
Brakes
Electrical
Diesel engine
The lubrication system of the diesel engine
The cooling system of the diesel engine
The power supply system of the diesel engine and turbocharger
Map service.
Applications
Wiring
 


Hit Counter by Digits


print page printable version

The principle of ECM under different conditions



When the ignition ECU includes elektrobenzonasos that creates fuel pressure in the fuel rail. At the same time, the computer processes the signal from the coolant temperature sensor to determine the necessary duration of the pulses for starting the injection. When the crankshaft of the engine during start-up begins to rotate, the computer generates a pulse inclusion nozzles, the duration of which depends on the temperature of the coolant.
When starting a cold engine injection impulse is increased, the injector open for a longer period of time and the amount of fuel injected more (get more rich fuel mixture).
When starting a warm engine control unit received information on the coolant temperature, gives a command to close the valve set of stabilization of idling, as a result of the injection pulse duration decreases and the opening of the nozzles is reduced to nominal.
At idle information in the computer comes from the throttle potentiometer located in the throttle body and the MAF sensor. By reducing the rotational speed is changed and the ignition timing of fuel injection pulse width is increased, thereby increasing the amount of injected fuel.
During normal operation of the engine throttle position and passing through the air flowmeter the amount of intake air is determined and the duration of opening of the injectors thereby engine operation.




« previos page
Precautions during repair work on the injection system
next page »
Injection system

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.