printable version
Removing and installing oil pan
Oil pan can be removed on the engine installed. Drain the engine oil. Remove protection crankcase. Remove the oil pan and gasket crankcase, if it remained on him.
| Fig. 452. View of the oil sump and disassembled oil pump 1 - the guide plate; 2 - oil receiving pipe; 3 - a bolt of oil receiving pipe 10 Nm; 4 - a sealing ring 10 Nm; 5 - the case of the oil pump; 6 - gear oil pump; 7 - the oil pump cover with pressure relief valve; 8 - short screw cap 10 Nm; 9 - long bolt cap to 25 N ?� m; 10 - oil sump; 11 - a sealing ring (always replace a new); 12 - drain plug, 30 Nm; 13 - oil pan bolt, 25 Nm
|
In Fig. 452 shown fixing the oil sump. Installing oil sump is done in the reverse order with respect to the process of withdrawal. Pay attention to the following points: - Thoroughly clean the contact surface of the cylinder block and oil pan; - Crosswise tighten the bolts to 25 Nm; - If you do not change the filter, then pour into the engine 4.0 liters of oil. Otherwise fill 4.2 liter engine oil. Remember the above recommendations for an excessive amount of engine oil in the engine. Subsection 4.6 are given some guidance on the use of motor oils, which should also pay attention.
|