add to favorites contacts sitemap
Volkswagen Sharan (from 1995 to 2000, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Sharan
eleven New VW Sharan
Vehicle identification
General recommendations for car repair
Working conditions and the used tool
Proper lifting vehicle
Repair and maintenance
Lubricants, sealants, Loctite
Handling screw connections, bolts, nuts
VR6 engine
The two-liter engine (ADY)
Engine oil
A fuel injection system VR6 engine
The system Simos injection 2.0-liter engine
The ignition system
Manual 5-speed gearbox
The drive shafts
Power steering
Front suspension
Rear suspension
Diesel engine
The lubrication system of the diesel engine
The cooling system of the diesel engine
The power supply system of the diesel engine and turbocharger
Map service.

Hit Counter by Digits

print page printable version

General recommendations for car repair

All descriptions in this manual repair quite clear and simple. Reference tables given at the end of the book, are very important and should be used during repair and maintenance of the car, as in the description of the individual processes in the text books are not always the necessary quantities and data, and this information should be specified in the tables. This is especially important when checking the data for a particular model, to eliminate the possibility of error.
When carrying out repairs and maintenance of the car, follow these guidelines:
- Nuts and bolts must be clean and lightly oiled. Always check the threads of nuts and bolts that it had no damage. If necessary, use new screws or nuts;
- Always replace self-locking nuts taken to the new;
- Always observe the specified tightening torques of threaded connections. Torque values are divided into groups in accordance with the sections of this guide that makes it easy to find the desired size;
- During assembly, replace all gaskets, seals, lock washers, pins and O-rings O-rings (circular ring). It is also necessary to replace the shaft sealing rings and radial shaft seals, when the shaft was removed from the sealing ring. Before installing the surface of the seal ring must be covered with grease. When installing it is necessary to pay attention to the fact that the oiled side looking in the direction from which may leak oil or grease;
- Pay special attention to secure the vehicle in the raised position, using, if possible, three-legged shell support;
- Grease, oil, anti-corrosion protection of underbody and all mineral substances aggressive act on the part of the rubber chassis and the brake system. Do not allow contact with such substances as well as fuels, especially in the rubber parts of the hydraulic system. To clean, use only brake brake fluid or alcohol. However, do not forget at the same time that the brake fluid can damage the paintwork of the car;
- After the repair work, always check the correct operation of systems and units of the car while driving.

« previos page
Vehicle identification
next page »
Working conditions and the used tool

Copyright © 2010 Trademarks belong to their respective owners. All rights reserved.