 printable version
Adjustment of a drive transmission control
After completing work associated with the separation of the drive gear, as well as fuzzy gear shifting operation to adjust the drive. You will need: the keys "12", "14".
| Fig. 6.5. Location adjusting hole plug: 1 - shaft gear; 2 - a cover of the gearshift; 3 - plug the holes of the adjustment; 4 - derailleur |
1. Remove the cap from the adjusting hole cover gearshift (Fig. 6.5). 2. Shift the transmission into neutral. | | 3. In the engine compartment, loosen the clamp connections of the shift actuator, to ensure the free movement of the tip relative shift lever and the rods. | 4. Turn the selector shaft so that the shaft diameter of 5.0 mm (for example, a suitable drill shank) inserted into the opening of the cover 2 (see. Fig. 6.5), was the insertion hole 4 switch. |
6. Set the gear lever to select the position I or II and the transmission, the holes in the retaining sleeve and the gear lever housing lever lock lever, inserting the aligned holes of the second rod with a diameter of 5.0 mm. 7. Tighten the terminal Connect the drive gear, remove the stems from the mounting holes on the gear lever cover and the gearshift and install the plug of the adjustment holes in the lid. 8. Check and accuracy of transmission. If necessary, repeat the adjustment.
| 
