REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Elantra (from 2000 to 2004, the year of issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Elantra
		Gasoline engines 1.6, 1.8 and 2.0 liters
		The diesel engine of 2.0 liters
		Greasing system
		Cooling
		Fuel system
		Control systems and emission control
		Ignition system
		The system of preliminary heating of the diesel engine
		Coupling
		Manual transmission
		Automatic Transmission
		Drive shafts, front and rear axles
		Suspension
		Steering
		Brakes
		Body
		The air conditioning system
			Technical data
			Instructions for use of the refrigerant
			Remarks at replacement of elements of the air conditioning system
			Merging an air-conditioning system
			Safety measures
			Setting gauges for pressure measurement
			Discharge the air conditioning system
			The evacuation of air from the air conditioning system
			Connecting the exhaust valve to the cylinder with the refrigerant
			Charge air-conditioning system
			Verification performance
			Oil for air conditioning compressor
			Check and adjust the tension of V-ribbed belts
			Air conditioning compressor
			Bushing clutch pulley and the air conditioning compressor
			The excitation coil clutch
			Checking clutch clearance
			Blower, and relay
			Receiver Drier
			Triple Sensor (double) Pressure
			Block heating and ventilation
			Fan
			Air filter
			Damper actuator supply fresh / recirculated air
			Check the fan motor
			Relay test
		Electrical equipment
		Electrical diagrams

printable version

Air conditioning compressor

The elements of the air conditioning compressor

1 - compressor clutch
2 - compressor
3 - cylinder and a shaft
4 - front cylinder
5 - rear cylinder
6 - the plug
7 - A ring bearing
8 - the bearing
9 - bearing the ring L
10 - a disc mounted at an angle to the shaft
11 - a shaft
12 - Block
13 - the piston
14 - E-ring of the bearing
15 - Spring
16 - front plate
17 - the block of the front plate
18 - front plate
19 - stud
20 - the block of the rear plate
21 - back plate
22 - discharge element
23 - head gasket
24 - Back pad
25 - a sealing ring
26 - rear section of the compressor

27 - the front section of the compressor
28 - a bolt
29 - flat washer
30 - shaft seal
31 - Ring
32-1 - seal
32-2 - mounting sleeve
32-3 - mounting sleeve
33 - excitation coil
34 - a pulley
35 - disc and hub
36 - Ring
37 - a lining
38 - a bolt
39 - the screw
40 - an arm of the connector
41 - collector assembly
42 - Collector
43 - suction pipe
44 - a branch pipe discharge
45 - safety valve
46 - O-ring
47 - stud
48 - a bolt
49 - Wrench
50 - a lining

Refitting

PERFORMANCE ORDER

Loosen and remove the air conditioning compressor belt.

Discharge the air conditioning system.

Remove the discharge hose and a suction hose.

Remove the air conditioning compressor. Immediately close all open apertures and tubes to eliminate moisture from the air in the air conditioning system.
Installation is performed in reverse order of removal.

« previos page
Check and adjust the tension of V-ribbed belts

next page »
Bushing clutch pulley and the air conditioning compressor