REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Santa FE (2006 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Santa FE
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
			Overview
				Checking and adjusting the brake pedal
				Check the operation of the brake servo without tester
				Removal of air from hydraulic brakes
				Removal, check and installation of the brake pedal
				Disassembly, inspection, assembly and installation of the main brake cylinder
				Pressure regulator rear brakes
				Removal, check and installation of the front brake pads
				Disassembly and assembly of front disc brakes
				Disassembly and assembly of rear disc brakes
				Removal, check and installation of the rear drum brakes
				Check and adjust handbrake lever stroke
				Anti-lock brakes
				Removal and installation of the electronic ABS control unit
				Checking the ABS hydraulic unit
				Removal and check wheel speed sensor (ABS)
				Check the operation of the ABS system
			Tables
		Onboard electric
		Body
		diagrams

printable version

Check the operation of the ABS system

Checking the voltage signal wheel speed sensor

Raise the vehicle and release the parking brake.

Disconnect the integrated control unit ABS (HECU) and measure on the connector at the harness side.

ATTENTION

Ensure that the double lock connector is removed, and the probe is inserted into the device from the wiring (the back of the connector). Connecting the probe directly to the terminals of the connector may cause an incorrect or insufficient connector contact.

Spin the wheel at approximately 0.5-1 revolution per second, and check the voltage sensor with a multimeter or oscilloscope.

The voltage signal

When measured with an oscilloscope: 130 mV or higher (signal amplitude).

« previos page
Removal and check wheel speed sensor (ABS)

next page »
Tables