add to favorites

REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Santa FE (2006 release)

general info. full specifications. diagnostics. hints. tips. tricks

Hyundai Santa FE

Home

Hyundai
	Santa FE
		Operation and maintenance of car
		Engine
		Transmission
		Chassis
		Steering Gear
		Brakes
			Overview
				Checking and adjusting the brake pedal
				Check the operation of the brake servo without tester
				Removal of air from hydraulic brakes
				Removal, check and installation of the brake pedal
				Disassembly, inspection, assembly and installation of the main brake cylinder
				Pressure regulator rear brakes
				Removal, check and installation of the front brake pads
				Disassembly and assembly of front disc brakes
				Disassembly and assembly of rear disc brakes
				Removal, check and installation of the rear drum brakes
				Check and adjust handbrake lever stroke
				Anti-lock brakes
				Removal and installation of the electronic ABS control unit
				Checking the ABS hydraulic unit
				Removal and check wheel speed sensor (ABS)
				Check the operation of the ABS system
			Tables
		Onboard electric
		Body
		diagrams

Hit Counter by Digits

printable version

Removal, check and installation of the brake pedal

Brake pedal

Fig. 6.7. Brake pedal

Withdrawal

Remove the brake light switch.

Remove the cotter pin and remove the earrings finger thrust.

Remove the nuts brake pedal bracket.

Pedal assembly with bracket

Fig. 6.8. Pedal assembly with bracket

Remove the bracket with the brake pedal (Fig. 6.8).

Check

Rate wear sleeves pedal.

Check for any deformation of the pedal.

Check the return spring.

Check the brake light switch.

Measure the resistance between terminal switch

Fig. 6.9. Measure the resistance between terminal switch

Use an ohmmeter to measure the resistance between the terminals of the switch (Fig. 6.9).

If pressing plunger switch open circuit (infinite resistance), and is released when the pusher is (zero resistance) - switch to normal.

Setting

Installation is in the reverse order.

Fixing pin pin earrings

Fig. 6.10. Fixing pin pin earrings

NOTE

Do not forget to lock the thumb stud earrings (Fig. 6.10).

Tighten the nuts pedal bracket regulated torque 13-16 Nm.

Adjust the height of installation of a pedal and its free stroke.

Install the brake light switch.

« previos page
Removal of air from hydraulic brakes

next page »
Disassembly, inspection, assembly and installation of the main brake cylinder

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.