REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Clarus (1995 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Clarus
		Maintenance
		Engines FE DOHC and DOHC T8
		Greasing system
		Cooling
			Technical data
			Coolant
			Checking the tightness of the cooling system
			Substitution coolant
			Check the radiator cap
			Radiator
			Water pump
			Thermostat
			Check the radiator fan
			Coolant temperature
			Radiator fan relay
			Troubleshooting
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		ACP G4A-EL
		AKP 50-40 LE
		Axes and power shafts
		Steering
		Wheels and tires
		Suspension
		Body
		The air conditioning system
		Electrical equipment
		Brakes
		Electric schemes

Water pump

1 - a gear belt;
2 - a pulley of a camshaft;
3 - gasket;

4 - a tension roller;
5 - the water pump;
6 - a lining.

Withdrawal

PERFORMANCE ORDER

1. Remove the radiator.
	2. Loosen the retaining bolts and the adjustment of the generator and remove the drive belt.
3. Rotate the crankshaft so that the piston of the first cylinder is at top dead center on the compression stroke (TDC).
4. Drain the coolant into a suitable container.
5. Remove the water pump in the following order: - toothed belt; - Camshaft pulley; - Gasket; - tension roller; - water pump; - Laying.

Check

PERFORMANCE ORDER

1. Check the water pump for cracks and damage.
	2. Turn the shaft of the water pump and check for smooth rotation in the absence of noise. If necessary, replace the water pump.

Setting

PERFORMANCE ORDER

1. Remove any remnants of gaskets and foreign material gasket sealing surface of the water pump.
	2. Place the rubber seal on the water pump.
3. Install water pump and secure it with screws. Torque: 19-25 N ??? m
	A warning To prevent falling during the installation of the pump gasket, apply a silicone sealant into the groove of the gasket, as shown in the figure. Do not apply sealant to the mating surface.
4. Further installation of the pump is carried out in reverse order of removal.
5. Fill in the required amount of cooling required coolant.
6. Connect the cable to the negative terminal of the battery.
7. Start up the engine and check for leaks from the cooling system.

« previos page
Radiator

next page »
Thermostat