|
printable version
Water pump
Sequence of removal of the water pump, thermostat and pipes of the cooling system 1 - inlet pipe cooling system and routing; 2 - bypass pipe and the O-ring; 3 - the water pump; | 4 - installation of the water pump; 5 - Thermostat |
Withdrawal PERFORMANCE ORDER | A warning Water pump is not repairable and if it fails, replace it in the assembly.
| 1. Disconnect the negative battery terminal. | 2. Remove the ancillary drive belt. | 3. Remove the timing belt. | 4. Remove the power steering pump to remove the inlet pipe cooling system. | 5. Remove all the parts in the sequence shown in the figure. |
|
Setting PERFORMANCE ORDER | 1. Check the water pump for cracks and damage. | 2. Turn the shaft of the water pump and check for smooth rotation in the absence of noise. | 3. If necessary, replace the water pump. |
|
Setting PERFORMANCE ORDER | 1. Remove any remnants of gaskets and foreign material sealing surface of the water pump. | 2. Replace the water pump new gasket. Avoid laying the fall, as the sealant applied on the gasket may be damaged. Place the gasket sealant to the side of the sealing surface. | 3. The further installation is carried out in reverse order of removal. | 4. Fill in the required amount of cooling required coolant. | 5. Connect the cable to the negative terminal of the battery. | 6. Start the engine and check for leaks from the cooling system. |
|
|
|