REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sephia / Shuma
		Maintenance
		Engine
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		Automatic Transmission
		Axes and power shafts
			Technical data
			Checking the bearing play of the front wheels
			Checking the status of the drive shaft
			A rotary fist and a nave of a forward wheel
			Rear axle
			Drive shaft
			Repair knuckle
			SHRUS type Tripoid
		Steering
		Wheels and tires
		Brakes
		Suspension
		Body
		The air conditioning system
		Electrical equipment

A rotary fist and a nave of a forward wheel

A rotary fist and a nave of a forward wheel

1 - wheel;
2 - a nut with a fillet;
3 - caliper front brake;
4 - Disc;

5 - tie rod end;
6 - the ball joint of the lower arm;
7 - knuckle and front hub

Withdrawal

PERFORMANCE ORDER

1. Lift the car and fix on support.
2. Remove the four wheel nuts.
3. Remove the wheel.
4. Peel back the fillet and turn away a nut of fastening of a power shaft to a nave and remove the two screws on the brake disc.
5. Remove the caliper and the brake disk.
A warning Do not damage the dust cover.
	6. Remove the cotter pin and loosen the nut trunnion ball joint tie rod to the steering knuckle. Stripper OK130 283 021 squeeze out a pin of the ball joint from the knuckle.
7. Remove the earring stabilizer bar from the lower control arm front suspension.
8. Remove the coupling bolt, mount wring out the bottom lever downwards and separate a pin of the hinge from a rotary fist.
9. Note the position and turn the bolts of the front lower arm to knuckle. Remove the steering knuckle and the hub of the front wheel.
10. Check the condition of all details and, if necessary, repair or replace the damaged parts.

Setting

PERFORMANCE ORDER

1. Install the steering knuckle and wheel hub bolts to fasten the bottom of the front suspension.
2. Establish a pin of the spherical hinge of the bottom lever in a rotary fist and fix a coupling bolt and nut. Torque: 43-54 N ??? m
3. Install the brake disc on the wheel hub and secure with two bolts. Torque: 10-15 N ??? m
4. Install the front brake caliper to the steering knuckle and secure with two bolts. Torque: 45-68 N ??? m
A warning Do not damage the dust cover.
5. Establish a pin of the spherical rod end to the knuckle.
	6. Screw the nut and cotter pin, lock them from loosening. Torque: 29-44 N ??? m
	7. Screw the new nut with a fillet and hammer in a nut fillet into the groove of the drive shaft. Torque: 210-279 N ??? m
8. Establish a wheel.
9. Tighten the wheel nuts. Torque: 88-118 N ??? m
10. Freely screw nuts earring of the stabilizer, and lower the car on the car standing on wheels, tighten the nuts. Torque: 43-61 N ??? m
11. Check the front wheels.

next page »
Rear axle