printable version
Parking brake
Check and adjust Pull the parking brake lever and ensure that the full integration takes place between 7 and 9 clicks. Start up the engine, depress the brake pedal two or three times and stop the engine.
| Fig. 10.15. Adjusting the parking brake lever stroke
|
Remove the cover and hand brake screwdriver to turn the adjusting nut until the course of the lever will not be in the desired range (Fig. 10.15). The parking brake in the dash should light up after tightening the lever one click. Lower the parking brake lever and make sure the rear brakes do not inhibit the vehicle.
Removal and installation of the parking brake assembly Remove the cover handbrake.
| Fig. 10.16. Elements site parking brake: 1 - the screw; 2 - an adjusting nut; 3 - the handle; 4 - button; 5 - a returnable spring; 6 - unit the parking brake; 7 - the screw; 8 - socket of the switch of a control lamp of a lay brake; 9 - Bolts
|
Disconnect the connector from the switch the parking brake (Fig. 10.16) .Otvernite adjusting nut. Remove the screws, remove the parking brake cable assembly and lift the lever to extract him from the car. Inspect the gear sector and pawl ratchet teeth for damage and check the resilience of the return spring. Replace damaged items with new ones. Before installation, lubricate the gear teeth of the ratchet sector and lubricant white lithium-based. Installation is performed in reverse order of removal. Adjust the parking brake.
Removal and installation of the parking brake Rear cable Lift the rear of the car and secure on stands. Remove the cable clamp. Remove the brake pad assembly and disconnect the cable from the drive lever brake pads.
| Fig. 10.17. Rear parking brake cable: 1 - bracket; 2 - a bolt; 3 - an adjusting nut; 4 - rear parking brake cable; 5 - connector cable with the lever drive of brake pads
|
Remove the screws and the mounting nut, remove the rear parking brake cable from the vehicle (Fig. 10.17). Installation is performed in reverse order of removal. Before installation, apply grease White lithium based on the sealing ring of the cable. After installing the adjusting nut to rotate until the compensator is positioned at an angle of 90 ?� to the front parking brake cable. If necessary, adjust the course of the handbrake lever. Front cable Remove the cover handbrake lever. Unscrew and remove the adjusting nut. Lift the rear of the car and secure on stands. Remove the front cable from under the car, disconnecting the cable from the rear of the compensator. Installation is performed in reverse order of removal. If necessary, adjust the course of the handbrake lever.
|