printable version
The drive of the accelerator pedal
If the pedal is simply "jam", grease and "costs" of it. After each washing the engine is required to lubricate the stem and the drive pedal. Adjust the fuel control unit and pressure control for models with automatic transmission spend in the workshop.
Adjustment of a drive of an accelerator pedal
| Fig. 4.82. Drive Accelerator: 1 - Drive pedal; 2 - an adjusting nut; 3 - bearing seat; 4 - fixing bracket; 5 - a returnable spring; 6 - Limiter sensor rocker arm; 7 - the lever sensor defined values; 8 - the gauge defined values; 9 - ball joint rotation sensor
|
1. Open the hood. Check the actuator stroke sensor to a free course. In case of poor operation replace the affected parts (Fig. 4.82). 2. The rotary lever must freely sensor adjacent to the stopper, and at the same time should not be backlash from the accelerator pedal. 3. Press the pedal until the moment when it reaches the pivot arm stop. 4. Turn the terminator in the reverse direction until it clicks. 5. On vehicles with automatic transmission: depress the accelerator pedal all the way. 6. Install the adjusting nut lever so that it rests on the free limiter. 7. Release the foot pedal. Adjust the nut behind the pedal so that the lever lay on the stopper.
Adjust full throttle on the accelerator pedal
| Fig. 4.83. The focus of the accelerator pedal: 1 - an emphasis; 2 - limiter
|
1. Rotate the left shall shoot focus full throttle 1 (Fig. 4.83) under the accelerator pedal and release the little bolt limiter 2. 2. Slowly press the accelerator pedal until the engine compartment sensor pivot arm rests on the stopper. 3. In this position, rotate the focus full gas right before fixing it with the pedal.
Replacing the drive accelerator
| Fig. 4.84. Details of the accelerator pedal 1 - a rubber tip, 2 - pedal arm, 3 - an adjusting nut 4 - Castle, 5 - foot, 6 - stop full throttle (with automatic transmission - the switch kick-down)
|
1. Remove the head with a ball joint sensor arm-defined values (Fig. 4.84). 2. To release the control cable. 3. Remove the casing in the area of the pedals. 4. Remove the control cable from the accelerator pedal. 5. Remove the cable from the outside of the cabin. This rubber sleeve on the body did not pull. 6. Remove the cable from the engine compartment. 7. Before installing the cable, check the rubber parts and replace them if necessary. 8. Lubricate cable and lever parts. 9. Place the cable in place.
|