Removal and installation of facing C-pillar

1. Remove the rear seat and fold it forward.
2. Remove the bolt underneath the seat belt.
3. Remove the edging along the rack C.

4. Remove the lining of the SRS-cover (1) and remove the screw located underneath.

5. Insert the plastic wedge into the gap between the C-pillar cladding and lining of the roof and remove the trim.
6. Remove the trim from the clips (2) from the front C (the arrow in the illustration) and pull it forward out of the guide shelf.
7. Spend a belt through the slot in the wall.

1. Installation is performed in reverse order of removal.
2. Fasten seat belt for the rear seat torque 30Nm.

1. Remove the rear seat and fold it forward.
2. Remove the side cushion rear seat back, as described in Section Removal and installation of a back seat.
3. Remove the edging along the rack C.
4. Remove the cover and disconnect the turn of the belt clip at the counter C.
5. Remove the liner in the cargo hold, refer to the appropriate section.

6. Remove the C-pillar trim of the holder bracket (2).

7. Remove the belt from the belt guide lining.

1. Installation is performed in reverse order of removal.
2. Secure the bracket rotation belt on C-pillar torque 30Nm.