REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mercedes-Benz C-Class (W203, 2000 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mercedes-Benz
	W203
		Introduction
		Instruction Manual
		Routine maintenance
		Engine
		Cooling and heating
		The power supply system and release
		Electric motor
		Manual gearbox
		Automatic Transmission
		Coupling and power shafts
		Brakes
		Suspension and steering
		Body
			Care and exterior equipment Body
			Salon Equipment
				Notes on handling the equipment interior and security measures
				Removing and installing the expander clamp
				Removing and installing the cover under the dashboard
				Removal and installation of the bottom of the instrument panel
				Removal and installation of the glove compartment
				Removing and installing the cover under the glove compartment
				Removing and installing center console
				Removal and installation of the upper lid of the center console
				Removing and installing interior mirror
				Removal and installation of facing in the cargo hold
				Removing and installing front seat
				Removing and installing rear seat
				Removing and installing shelves
				Removal and installation of facing racks A and B
				Removal and installation of facing C-pillar
		Onboard electric

printable version

Salon Equipment

When working inside the vehicle equipment must be kept in mind the following:

?� To remove plastic coverings and linings is recommended to use a plastic wedge, for example, HAZET 1965-20.
?� Clips, damaged when removing the linings must always be replaced.
?� Seats, seat belts and airbags are important in terms of safety elements of the vehicle equipment. Based on the precautions themselves only perform the work described herein. More complex work must be performed in the workshop.

If the part of the body work is also necessary to carry out any work on the electrical system, you must always disconnect the negative cable (-) battery. To do this, see the section Replacing the battery. As the electrical work should be considered, even off the electrical wires of any output.

It is mandatory to comply with security measures on the airbag, in particular when working on the instrument panel and center console, refer to Section safety instructions for airbag.
To prevent airbag deployment is necessary to turn off the ignition cable before undocking airbag system, and then disconnect first the negative (-) and then the positive (+) cable of the battery. In addition, for safety reasons it is necessary to isolate the negative pole of the battery, refer to Section safety instructions for airbag.

« previos page
Removal and installation of covers of the cargo hold

next page »
Notes on handling the equipment interior and security measures