|
|
 printable version
Removal and installation of electric drive valves
Electric motors drive the air conditioning air flaps
 | 1 - e / m actuator valve of the left duct blowing glass
2 - e / m drive left overlapping flap
3 - e / m door actuator right air blowing glass
4 - e / m control valve of the coal filter
5 - e / m fan
6 - e / m actuator valve switch modes of circulation | 7 - E / m drive right overlapping flap
8 - E / m drive air baffle right foot wells
9 - E / m privooda left flap fresh air
10 - E / m privooda right flap fresh air
11 - E / m drive air baffle left foot well |
Model conditioner without automatic comfort
Ventilation flaps are moved with the help of electric motors. Electric motors mounted on the block heater / air conditioner. To access the electric motors must remove various covers.
Withdrawal
|  | 1. Disconnect the negative (-) cable of the battery when the ignition is off. You must first remove the air filter box of the passenger compartment. |
2. The valve of fresh air / circulation: Remove the cover under the glove compartment, refer to the appropriate section.
3. air mixing flap right: Remove the cover under the glove compartment, refer to the appropriate section.
4. air mixing flap left: Remove the cover under the dashboard on the driver, refer to the appropriate section. |
|
The damper the area of the leg
| 1. Remove the cover under the dashboard on the driver, refer to the appropriate section.
2. Remove the lower part of the dashboard on the driver's side, refer to the appropriate section.
3. Remove the radio and a pocket under the radio, refer to Section Removal and installation of the radio.
4. Remove the damping material. |
|
Ventilation flap
| 1. Remove the heater and air conditioner, refer to the appropriate section.
2. Remove the radio and a pocket under the radio, refer to Section Removal and installation of the radio.
3. Remove the damping material.  | 4. Remove the 3 screws (arrows in the illustration) and remove the electric motor (1). |
5. Disconnect the connector (2) of the electric motor. |
|
Setting
| 1. Installation is performed in reverse order of removal.
2. Attach a weight cable (-) battery when the ignition is switched off. Replace the cabin air filter box. If necessary, enter the code for the radio and set the time on the clock.  | After installation, you must adjust the electric motor drive ventilation flaps on the control unit. On STO for this purpose there is a special diagnostic tool. |
|
|
|
|
