printable version

Installation of the clutch

Setting the clutch in the reverse order. Please note the following points:

PERFORMANCE ORDER

For centering drive plate is usually required centering rod (KV30101000), shown in the illustration. If this bar is not possible to use existing shaft coupling. If both possibilities can not be used, it is possible to align the drive plate via a rod, whose outer diameter corresponds to the inner diameter of the splined connection. This rod screw pin, which has the same internal diameter as the guide bearing in the crankshaft. Craftsmen can align the drive to the eye. When installing the drive plate, set a longer side of the disc hub out t. E. The gearbox. Using a special centering rod during installation of coupling. Before installing the clutch cover with shaft splines small amount of grease. If you install the old clutch, set the clutch basket on the mark on the handwheel. Tighten bolts of clutch crosswise in several passes in the order shown in the with a force of 22 - 29 N ??? m. It is often removed and insert the centering rod to check the installation.