| 1. Remove the right axle. |
| 2. Remove the inner CV joints, bearings and bearing housing. |
| 3. Hold the axle shaft in a vise and Xpress gryazeotrazhatel hammer on the mandrel. |
| 4. Pry and remove the bearing cover on the side that faces inward. |
| 5. Remove the bearing retaining ring. |
| 6. Xpress bearing assembly to the body from the axle shaft. If the bearing is changed, it can be gently knock hammer on the mandrel. |
| 7. Remove the bearing retaining ring from the outside. |
| 8. Remove the bearing cap. |
| 9. Extract the bearing housing from the blows of the mandrel, which rests on the outer ring. |
| 10. Before assembly, put in the bearing grease. |
| 11. Press in the bearing in the housing so as to be able to install the cover and retaining ring. |
| 12. Install the palm under the inner ring and press-fit into the bearing axle shaft blows to end through the wooden prorate so that you can install an internal lock ring. |
| 13. Carefully press them gryazeotrazhateli. |
| 14. Install the CV joint. |
| 15. Install the shaft. |
