add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Nissan Terrano II (from 1985 to 1999 model year)

general info. full specifications. diagnostics. hints. tips. tricks
Nissan Terrano 2
Home
 
Nissan
Terrano 2
Operation and Maintenance
Maintenance Vehicle
The four-cylinder engine
Engines VS
All engines
Systems of cooling, heating, ventilation and air conditioning
Fuel and an exhaust system
The system of electric motor
Emission of exhaust gases
Manual transmission
Automatic Transmission
Coupling the propeller shaft and rear axle
Chassis car with wheel formula 4x4
Brakes
Suspension and steering
Body and trims
Electrical system
Technical data
Overview
Troubleshooting - General
Fuses - general information
Fusible link - an overview
Relays - overview
Switches - check
Direction indicators and alarms - an overview
Lights - regulation
Lights - removal and installation
Lamps - Replacement
Horn - check
Beep - removal and installation
Windscreen wiper - General
Motor glass cleaner - removal and installation
Windscreen - removal and installation
The unit switches on the steering column - removal and installation
Ignition switch - removal and installation
Instrument panel - removal and installation
Receiver - removal and installation
Cigarette lighter - removal and installation
Switch unit, light - removal and installation
Switch alarm - removal and installation
Rear window defroster switch - removal and installation
Thermocouple for heated rear window - removal and installation
Airbags - general information
Schemes of installation and electrical schematic
 


Hit Counter by Digits


print page printable version

Horn - check



1. Cars equipped with sound signals of high and low tones, which are mounted behind the front bumper under the headlights. Signals includes a button either in the center wheel, either one of the side push buttons (for the vehicle). Horn relay is mounted under the dashboard on the left side.
2. If there is no signal, check the fuse.
3. If the fuse is OK, disconnect the wire from one of the signal and connect the signal directly to the battery. If there is no signal, the signal is either defective or there is an open connection to the ground. Similarly, check the other signal.

10.2 Replacement Lamps priborov1. Courtesy light and cargo otseka2. Plafond of illumination of license znaka3. Rear combination lamp4. Front povorotov5 repeater. Front turn signal
10.2 Replacement lamps lighting
1. Courtesy light and the cargo compartment
2. Ceiling light plate
3. Rear combination lamps
4. The front repeater of turns
5. The front turn signal


10.3 chucks 4 types used in lighting priborah1. Snyat2. Set
10.3 chucks 4 types used in fryers
1. Remove
2. Set


4. If the connection with the battery signal is, then the fault signal relay. You should also check the contact connection with weight on the steering column and wires.




« previos page
Lamps - Replacement
next page »
Beep - removal and installation

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.