add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Golf IV (1997 release)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Golf 4
Home
 
Volkswagen
Golf 4
Instructions
Engine
Cooling system
Fuel System
Exhaust system
Ventilation and heating system
Coupling
Transmission
Suspension brackets and power shafts
Front suspension
Rear suspension
Steering
Wheels and tires
Brakes
Body
Electrical equipment and wiring
 


Hit Counter by Digits


print page printable version

Suspension brackets and power shafts



Front suspension

1 - suspension strut;
2 - strut;
3 - knuckle;
4 - the external hinge;
5 - connecting bolt;
6 - transverse lower arm
front suspension;
7 - bar;
8 - the drive shafts;
9 - anti-roll bar;
10 - plastic coupling rod;
11 - the steering transmission;
12 - Rod steering transfer

Elements of front suspension

1 - mounting bracket;
2 - a nut welded to the body;
3 - Anti-reliance;
4 - Self-locking nut. When you install a new nut should be used;
5 - M 14h1,5h63 bolt 100 Nm + tighten
at an angle of 90 ?�. When installing, use a new bolt;
6 - back support;
7 - M 12h1,5h70 bolt, 70 Nm + tighten
at an angle of 90 ?�. When installing, use a new bolt;
8 - plate with nuts;
9 - Self-locking nut, 45 Nm. When installing, use
new nut;
10 - the external hinge;
11 - a bolt, 20 Nm + tighten on a corner 90 ?�.
When installing, use a new bolt;
12 - the lower arm front suspension;
13 - the connecting rod;
14 - a bolt, 45 Nm;
15 - Self-locking nut, 30 Nm. When you install a new nut should be used;
16 - anti-roll bar. To remove the need to lower the bottom crossbeam;
17 - a bolt with hexagon socket;
18 - M 14h1,5h95 bolt 100 Nm + tighten on a corner 90 ?�. When installing, use a new bolt;
19 - front support;
20 - M 12h1,5h82 bolt, 70 Nm + tighten on a corner 90 ?�. When installing, use a new bolt;
21 - 10h70 bolt M 50 Nm;
22 - 10h30 bolt M 50 Nm;
23 - Pendulum Bearing;
24 - a bolt of M 8h48 25 Nm;
25 - Rubber Bearing;
26 - clamp support;
27 - a bolt, 25 Nm;
28 - lower crossbeam

Suspension is the link between the body and wheels. Through them, to the body forces acting on the wheel. The elements included in the suspension, soften dynamic loads, reduce body movements, provide good stability and smooth running of the car.

The front suspension coil springs and shock absorbers is a compact spring strut. The upper part of the strut is attached to the body, and the lower - to the steering knuckle. The lower part of the steering knuckle is attached to trehplechemu lower arm front suspension. The lower front suspension arms are connected to the beam. The beam through the rubber bearing is connected to the body.

The torque from the transmission to the wheels is transmitted using the drive shaft with constant velocity joints.


A warning

It is strictly forbidden to carry out welding and straightening work on the elements of the front suspension. Always Replace self-locking nuts and bolts with traces of corrosion.






« previos page
Check adjustment
next page »
Front suspension

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.