printable version
Start the engine after major repairs
After the installation of the engine in the vehicle, check the engine oil level and coolant. Remove the spark plugs. Remove the power relay or fuel pump fuse for its dead. Rotate the crankshaft starter to turn off the lamp emergency oil pressure. If the lamp does not go out within a few seconds after the start of rotation of the crankshaft, turn off the starter and check the engine oil level and the condition of the oil filter. Next, check the integrity of the wire gauge of emergency pressure of oil. Install the spark plugs. Set the power relay or fuel pump fuse. Start up the engine and check the tightness of all systems. Dymlenie engine start - normal, as oil burns, hitting on the parts in the assembly of the engine. Recheck the engine oil and coolant after several minutes of engine operation. If during the repair to the engine set new pistons, piston rings and liners of the crankshaft, it is necessary to perform run-up to 1000 km. If you do not operate the engine run-in with a maximum load. After the completion of the running is recommended to replace the engine oil and oil filter.
|