add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Passat B6
Home
 
Volkswagen
Passat B6
Operation and maintenance of car
Engine
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Overview
Power supply system
Lighting
Removing the lights
Installing lights
Adjusting the headlights
Replacing the lamp beam
Replacing the lamp beam
Replacing the parking light bulb
Removal and installation of servo-leveling, headlamp manufacturer - Hella
Removal and installation of servo-leveling, headlamp manufacturer - Valeo
Check headlight adjustment
Check headlight adjustment via vyverochnogo screen without adjusting the 15 ?�
Adjusting headlamp with gas discharge lamps
Adjusting the main headlights with halogen lamps
Main Headlights with gas discharge lamps
Replacing gas-discharge lamp
Removing and installing front turn signal lamp
Removing and installing lighting in the door mirrors to facilitate landing
Removing and installing the rear light in the sidewall of the body
Removing and installing light plate (sedan)
Removing and installing the license plate light, station wagon (Variant)
Removing and installing bonnet contact switch
Removing and installing light switch
Removal and installation of a regulator-leveling and dimmer buttons and instrument panel
Removal and installation of a control lamp off the front passenger airbag
Removal and installation of lighting the glove box
Removal and installation of a control lamp central locking SAFE function
Replacement of ceiling lighting front of the cabin
Removing and installing center console switches
Removing and installing the main fuse box
Removal and installation of the switching unit on the left side of the engine compartment
Removal and installation of the relay unit on the left side of the front panel
General information on repair electricians of the car
Repair wire CAN bus
Broken wire with repair in two places
Repair of contacts in the connector housing
Mechanical locking connector housing
Round contacts
Flat contacts with asymmetrical locking tongues
Body
diagrams
 


Hit Counter by Digits


print page printable version

Check headlight adjustment via vyverochnogo screen without adjusting the 15 ?�



Main headlights

Vyverochny screen
Fig. 7.67. Vyverochny screen


Check, whether horizontal boundary lines of light and shadow on the surface of the screen 1 when the dipped and held there inflection point 2 between the left and right horizontal part of the ascending part of the boundary of light and shadow vertically through the central core of the mark 3. The light beam should be on the right the vertical line (Fig. 7.67).

NOTE
For easy identification of the inflection point 2 repeatedly shut and re-open the left half of the light (with respect to the direction of motion). Finally, check again dipped.
With proper adjustment of the light beam middle of the driving beam must be at the center mark 3.

15 ?° adjusting line
Fig. 7.68. 15 ?� adjusting line


For previously used vyverochnogo screen with 15 ?� adjusting line are the same adjustment parameters as well as for the new screen. to avoid improper adjustments should not include more than 15 ?� adjusting line (Fig. 7.68).

Fog lights

Driving test the boundaries of light and shadow
Fig. 7.69. Driving test the boundaries of light and shadow


Check, whether the upper limit of light and shadow adjustment line, and that it extends horizontally across the width of the screen (Fig. 7.69).

Other extra lights
Finally, you must check and adjust additional lights installed other operating systems for their requirements.




« previos page
Check headlight adjustment
next page »
Adjusting headlamp with gas discharge lamps

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.