add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Volkswagen Passat B6 (from the year 2004)

general info. full specifications. diagnostics. hints. tips. tricks
Volkswagen Passat B6
Home
 
Volkswagen
Passat B6
Operation and maintenance of car
Engine
Transmission
Chassis
Steering Gear
Brakes
Onboard electric
Overview
Power supply system
Lighting
Removing the lights
Installing lights
Adjusting the headlights
Replacing the lamp beam
Replacing the lamp beam
Replacing the parking light bulb
Removal and installation of servo-leveling, headlamp manufacturer - Hella
Removal and installation of servo-leveling, headlamp manufacturer - Valeo
Check headlight adjustment
Check headlight adjustment via vyverochnogo screen without adjusting the 15 ?�
Adjusting headlamp with gas discharge lamps
Adjusting the main headlights with halogen lamps
Main Headlights with gas discharge lamps
Replacing gas-discharge lamp
Removing and installing front turn signal lamp
Removing and installing lighting in the door mirrors to facilitate landing
Removing and installing the rear light in the sidewall of the body
Removing and installing light plate (sedan)
Removing and installing the license plate light, station wagon (Variant)
Removing and installing bonnet contact switch
Removing and installing light switch
Removal and installation of a regulator-leveling and dimmer buttons and instrument panel
Removal and installation of a control lamp off the front passenger airbag
Removal and installation of lighting the glove box
Removal and installation of a control lamp central locking SAFE function
Replacement of ceiling lighting front of the cabin
Removing and installing center console switches
Removing and installing the main fuse box
Removal and installation of the switching unit on the left side of the engine compartment
Removal and installation of the relay unit on the left side of the front panel
General information on repair electricians of the car
Repair wire CAN bus
Broken wire with repair in two places
Repair of contacts in the connector housing
Mechanical locking connector housing
Round contacts
Flat contacts with asymmetrical locking tongues
Body
diagrams
 


Hit Counter by Digits


print page printable version

Mechanical locking connector housing



Re-mount - a lock plug housing, which captures all the wires in the connector housing. If the connector housing has a secondary fastening, before unlocking and removing individual contacts it is necessary to open or remove using a special tool, lock picks.
Re-mount connector housing is allocated to a different color. This facilitates the detection of the secondary fastening and clarifies the principle of its operation.
The pictures here are shaped connector housings are not only throughout their range, they only demonstrate various principles of secondary attachment.

EXAMPLE 1

Location scallop
Fig. 7.137. Location scallop


Lock the housing must be unlocked by removing the "comb" (Fig. 7.137).

EXAMPLE 2

Unlock Lock
Fig. 7.138. Unlock Lock


Opening the "tongue", you can unlock the lock connection (Fig. 7.138).

EXAMPLE 3

Location valve
Fig. 7.139. Location valve


Locking device can be unlocked by pulling the "latch" (Fig. 7.139).




« previos page
Repair of contacts in the connector housing
next page »
Round contacts

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.