printable version
Removing and installing power steering pump
| Fig. 256. Parts attaching the power steering pump and the bracket: 1 - ribbed belt; 2 - pulley; 3 - bolts 25 Nm; 4 - O-ring; 5 - banjo bolt-fitting, 30 Nm; 6 - pressure line; 7, 8, 9, 11 - bolts 45 Nm; 10 - bolt 25 Nm; 12 - the inlet tube; 13 - clamp tube; 14 - power steering pump
|
Details of mounting the power steering pump are shown in Fig. 256. When installing observe all the specified torque. All shot spring washers and self-locking nuts must be replaced when you install new ones. The pump before installing fill in hydraulic oil G 002 00 and turn the pump pulley a few turns to allow the oil to settle. When connecting the tube 10 to see to it that it is not twisted. Be sure to replace the O-rings 4 pressure line. Banjo bolt-fitting 5 tightening torque of 30 Nm. If the pump and the console is removed, then the installation must be tightened fastening in the following order: - First "fit flush" all of the bolts; - Tighten to 45 Nm bolt 7, and then the bolts 8, 9 and 11. The bolts 9 and 11 of the same length, the same applies to the bolts 7 and 8.
|