REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Hyundai Accent (2000 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Hyundai
	Accent
		Instructions
		Engine
		Greasing system
		Cooling
		Control, reduced toxicity
		Fuel system
		Ignition system
		Coupling
		Transmission
		Axes and power shafts
		Suspension
		Steering
		Brakes
			Technical data
			Anti-lock brakes (ABS)
			Bleeding the hydraulic system of a drive of brakes with scanner use
			Checking and adjusting the brake pedal position
			Check the brake servo
			Bleeding the hydraulic system of a drive of brakes
			Adjust the parking brake stroke
			Vacuum brake booster
			Brake tubes and hoses
			Pressure regulator
			Brake pedal
			Replacing the front brake pads
			Caliper front brake
			The main brake cylinder
			Replacing brake pads on the rear drum brakes
			Replacing the working brake cylinder
			Parking brake
			Hydraulic block HECU ABS
			Wheel speed sensor
			Troubleshooting
		Body
		Air
		Electrical equipment
		Appendix
		Wiring

Checking and adjusting the brake pedal position

PERFORMANCE ORDER

	1. Turn the stop lamp switch until the required gap between the switch and the brake pedal, then tighten the lock nut locking switch. The gap between the pedal and the brake light switch: 0.5-1.0 mm
	2. With the engine switched off, press the brake pedal several times to remove any backlash in the system. Hand press the brake pedal before occurrence of notable resistance and measure a pedal free wheeling. Free running of the brake pedal: 3-8 mm
	3. Start the engine and depress the brake pedal force of 50 kg, and measure the distance from the floor to the center cushion of the brake pedal. The minimum distance of the brake pedal from the floor: 70 mm When the pedal is fully depressed, without the brake fluid: 50 mm