REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Clarus (1995 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Clarus
		Maintenance
		Engines FE DOHC and DOHC T8
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		ACP G4A-EL
		AKP 50-40 LE
			Technical data
			Friction mechanisms
			Locking mechanism
			Search and definition of malfunctions
			Fault codes
			Diagnostic connector
			Cleanup operation
			Testing time lag
			Testing of teamwork of an automatic transmission and the engine for the motionless car
			Testing of pressure transmission fluid
			Testing for the pressure reduced by the valve
			Check of level and a liquid condition in an automatic transmission
			Position sensor
			The switch of keeping of transfer
			Mode Switch
			Brake light switch
			The temperature sensor Transmission Fluid ATF
			Check resistance of speed sensor (output)
			Check resistance of speed sensor (input)
			Solenoid valves
			Changing the O-ring transmission fluid temperature sensor
			The lateral casing of a transmission
			Speed Sensor (input and output)
			Valves of switching of transfer (?��1, ?��2)
			Tube oil cooler
			Dismantling and transmission assemblage
			Note on disassembling
		Axes and power shafts
		Steering
		Wheels and tires
		Suspension
		Body
		The air conditioning system
		Electrical equipment
		Brakes
		Electric schemes

printable version

Position sensor

Operability test

PERFORMANCE ORDER

1. Check that the starter works only when the key is in the ignition switch is turned to the start position by moving the shift lever to the range of "P" or "N".

2. Check the switch reversing light when turning the key in the ignition switch in the ON position.

3. malfunction Check encoder.

Check conduction circuit

PERFORMANCE ORDER

1. Disconnect from the position sensor.
	2. Check for continuity between the contacts of the sensor at different positions of the selector lever.
A warning The conductivity of the position sensor varies with temperature because of the presence therein of lubricant. Especially check circuits conductivity at low temperatures, since the viscosity of lubricant at low temperatures is increased.
3. If the position does not satisfy the specification, replace it.

Adjustment

PERFORMANCE ORDER

1. Move the gear shift lever in the range of "N".
2. Remove the bolts position sensor.
	3. Align the mating marks on the sensor position.
4. Tighten the screws. The inhaling moment: 19,6-29,4 N ??? m
5. Recheck the position sensor circuit conductivity.
6. A negative result, replace the encoder.

« previos page
Check of level and a liquid condition in an automatic transmission

next page »
The switch of keeping of transfer