add to favorites contacts sitemap
REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Clarus (1995 issue)
general info. full specifications. diagnostics. hints. tips. tricks
 Kia Clarus
Home
 
Kia
Clarus
Maintenance
Engines FE DOHC and DOHC T8
Greasing system
Cooling
The power supply system and release
Fuel system
Ignition system
Coupling
Manual transmission
ACP G4A-EL
AKP 50-40 LE
Technical data
Friction mechanisms
Locking mechanism
Search and definition of malfunctions
Fault codes
Diagnostic connector
Cleanup operation
Testing time lag
Testing of teamwork of an automatic transmission and the engine for the motionless car
Testing of pressure transmission fluid
Testing for the pressure reduced by the valve
Check of level and a liquid condition in an automatic transmission
Position sensor
The switch of keeping of transfer
Mode Switch
Brake light switch
The temperature sensor Transmission Fluid ATF
Check resistance of speed sensor (output)
Check resistance of speed sensor (input)
Solenoid valves
Changing the O-ring transmission fluid temperature sensor
The lateral casing of a transmission
Speed Sensor (input and output)
Valves of switching of transfer (?„–1, ?„–2)
Tube oil cooler
Dismantling and transmission assemblage
Note on disassembling
Axes and power shafts
Steering
Wheels and tires
Suspension
Body
The air conditioning system
Electrical equipment
Brakes
Electric schemes
 


Hit Counter by Digits


print page printable version

Solenoid valves



Check

PERFORMANCE ORDER
1. Unplug the connector from the solenoid valves AKP.
2. Measure the resistance between each contact and "weight".

Resistance:
valves ?„–1, ?„–2: 12-16 Ohms
the pressure control valve: 3.3-3.7 ohms
blocking valve: 11-15 Ohms

A warning

Valve ?„–1 (switching 1-2,3-4): To

Valve ?„–2 (switches 2-3): L

Blocking valve: J

Pressure control valve: G, H

3. At discrepancy of values check for breaks or short circuits in the wires. Replace the valve.

Check conduction circuit

PERFORMANCE ORDER
1. Disconnect the 26-pin connector on the automatic transmission control unit.
2. Check for continuity between tracks V, Y, Z and "weight" (valves number 1, ?„– 2).
3. Check for continuity between tracks A and U (pressure control valve).
4. At negative results check for breaks or short circuits in the wires.




« previos page
Check resistance of speed sensor (input)		 next page »
Changing the O-ring transmission fluid temperature sensor

Copyright © 2010 AutoManuals.biz. Trademarks belong to their respective owners. All rights reserved.