REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Clarus (1995 issue)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Clarus
		Maintenance
		Engines FE DOHC and DOHC T8
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		ACP G4A-EL
		AKP 50-40 LE
			Technical data
			Friction mechanisms
			Locking mechanism
			Search and definition of malfunctions
			Fault codes
			Diagnostic connector
			Cleanup operation
			Testing time lag
			Testing of teamwork of an automatic transmission and the engine for the motionless car
			Testing of pressure transmission fluid
			Testing for the pressure reduced by the valve
			Check of level and a liquid condition in an automatic transmission
			Position sensor
			The switch of keeping of transfer
			Mode Switch
			Brake light switch
			The temperature sensor Transmission Fluid ATF
			Check resistance of speed sensor (output)
			Check resistance of speed sensor (input)
			Solenoid valves
			Changing the O-ring transmission fluid temperature sensor
			The lateral casing of a transmission
			Speed Sensor (input and output)
			Valves of switching of transfer (?��1, ?��2)
			Tube oil cooler
			Dismantling and transmission assemblage
			Note on disassembling
		Axes and power shafts
		Steering
		Wheels and tires
		Suspension
		Body
		The air conditioning system
		Electrical equipment
		Brakes
		Electric schemes

Valves of switching of transfer (?��1, ?��2)

Withdrawal

PERFORMANCE ORDER

1. Disconnect the negative battery terminal.
2. Remove the drain plug and drain the transmission fluid ATF.
A warning When you remove the side casing, be careful not to damage the cover, gearbox and contact surfaces. Replace the side casing if it is damaged.
	3. Unscrew the bolts and remove the side cover.
4. Disconnect from the valve.

Check

PERFORMANCE ORDER

Measure the resistance between the terminals of the solenoid valve.

Resistance: 12-16 Ohm

Setting

PERFORMANCE ORDER

1. Install the shift valve. The inhaling moment: 58,8-68,6 N ??? m
A warning Clean the contact surface of the housing side of the ATF and the remains of sealant. Apply sealant to the inside of the holes for the mounting bolts, without interrupting the application of sealant strip.

2. Apply sealant (three bond 1281B) on the side of the casing.
A warning A strip of the sealant should have a width of 1.0-1.5 mm. Node is subject to the assembly no later than 5 minutes after applying sealant.
3. Replace the cover and fasten the side screws. Torque: 20-29 N ??? m
4. Install a new gasket and replace the drain plug. Torque: 24-55 N ??? m
5. Fill the transmission fluid ATF and check for leaks from the side of the casing.