|
|
 printable version
Check clutch
| PERFORMANCE ORDER |  | 1. Check the clutch facings and at presence with them of traces of oil or mechanical damages replace a coupling disk. |
A warning  Minor contamination remove fine sandpaper.
| | 2. Check the riveted joints friction linings to the disc clutch. In the presence of defects, replace the clutch disc. |  | 3. Check the protrusion of the friction linings over heads of rivets. If the protrusion is less than acceptable, replace the clutch disc. The protrusion: 0.3 mm |  | 4. Insert a disc clutch on the mandrel in the centers and the indicator of hour type measure its palpation. If palpation above admissible, replace a coupling disk. The axial run-out: 0.7 mm
The radial run-out: 1.0 mm | | 5. Check clutch disc for rust in the slots. If there is rust, remove it. |
|
Setting
| PERFORMANCE ORDER |  | 1. Place the clutch disc and center its special mandrel OK130 160 010. |
A warning Align the marks on the flywheel and clutch cover, put before removal.
| | 2. Install the clutch cover with a press disk on directing pins of a flywheel. |  | 3. Gradually in diagonal sequence and in a certain order, tighten the flywheel bolts. Torque: 18-26 N ??? m | | 4. Remove the special holder OK130 160 010. |
A warning Before installing gearbox Clean the spline on the clutch and apply a thin layer of grease on the basis of molybdenum disulphide.
| | 5. Install the gearbox. |
|
|
|
