|
printable version
Clutch cover and the pressure plate
Withdrawal
PERFORMANCE ORDER | 1. Remove the gearbox. | 2. Mark the relative position of the clutch pressure plate and flywheel. Gradually loosen the bolts diagonally clutch assembly, turning each bolt on the S turn up until not stop the action of the diaphragm spring and bolts can be unscrewed by hand. Remove the clutch cover with the pressure plate and clutch disc. | A warning To eliminate rotation of the flywheel bolts set at reversing a special tool OK130 111 002 for blocking of a flywheel from turning.
| | 3. Remove the flywheel bolts. |
|
Check the flywheel PERFORMANCE ORDER | | 1. Check the condition of the friction surface of the flywheel for cracks, metal penetration and wear surfaces. The following slight generation or burning should be removed with sandpaper. | | 2. Check the condition of the teeth of the flywheel for wear, and mowing. If necessary, replace the flywheel as follows:
- Blowtorch heat flywheel and knock it with the flywheel; - Heat the flywheel to a temperature of 250 ~ 300 ?� C, place it on the flywheel. | A warning Sloping side of the ring gear must be positioned on the part of the cylinder.
| | 3. The indicator of hour type measure palpation of a flywheel. Heartbeat: 0.2 mm If the runout exceeds the limit, pereshlifuyte or replace the flywheel. The maximum permissible value of the rounding of the flywheel: 0.5 mm |
|
Check of the central bearing PERFORMANCE ORDER | | Thumb turn the bearing with the application of maximum force in the axial direction. If the bearing is turned hardly, replace it. |
|
Setting PERFORMANCE ORDER | 1. Clean the threads of the mounting bolts of the flywheel of the hermetic rests. | | 2. Before screwing bolts put on a carving of fresh sealant. | 3. Establish a flywheel and special adaptation OK130 111 002, safeguarding it against rotation. | | 4. In certain sequence tighten bolts of a flywheel. Torque: 96-103 N ??? m | 5. If the new flywheel must be installed in the central flywheel bearing. |
|
|
|