REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sephia / Shuma
		Maintenance
		Engine
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		Automatic Transmission
		Axes and power shafts
		Steering
		Wheels and tires
		Brakes
		Suspension
			Technical data
			Check and adjust wheel alignment
			Lower arm front suspension
			Front stabilizer
			Cross-section drafts and the longitudinal lever Rear suspension
			Rear anti-roll bar
			The transverse beam rear suspension
			Repair strut front suspension
			Repair strut rear suspension
		Body
		The air conditioning system
		Electrical equipment

Front stabilizer

Front stabilizer

1 - nuts earring of the stabilizer;
2 - earring of the stabilizer;
3 - mounting bolt;
4 - an arm of the stabilizer;

5 - sleeve stabilizer;
6 - stabilizer;
7 - a nut of fastening of steering transfer

Withdrawal

PERFORMANCE ORDER

1. Lift the front of the car and fix on supports.
2. Remove the wheel.
3. Remove the mudguard of a motor compartment.
4. Remove the nuts and disconnect earrings of the stabilizer from the stabilizer.
	5. Remove the nuts and disconnect earrings of the stabilizer from the bottom levers of the front suspension.
6. Remove the two nuts bracket steering gear and temporarily move the steering gear.
	7. adaptation OK201 170 AA0 support the engine and remove the six bolts crossbar.
8. Lower the crossmember so that it was possible to bring the stabilizer from under the crossbar.
9. Remove the stabilizer.

Setting

PERFORMANCE ORDER

1. Place the stabilizer bushing according to the adjusting labels put on the stabilizer.
2. Place stabilizer behind the crossbar.
3. Lift the crossbar and fasten with six screws. Torque: 93-127 N ??? m
	4. Tighten the two nuts of fastening of an arm of steering transfer. Torque: 31-46 N ??? m
5. Install the earring of the stabilizer on the lower arms and fix their nuts. Torque: 43-61 N ??? m

A warning

Tighten the nuts earring of the stabilizer to the bottom lever demanded moment after car installation on wheels (under load).