REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Kia Sephia / Shuma (1995 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Kia
	Sephia / Shuma
		Maintenance
		Engine
		Greasing system
		Cooling
		The power supply system and release
		Fuel system
		Ignition system
		Coupling
		Manual transmission
		Automatic Transmission
		Axes and power shafts
		Steering
		Wheels and tires
		Brakes
		Suspension
			Technical data
			Check and adjust wheel alignment
			Lower arm front suspension
			Front stabilizer
			Cross-section drafts and the longitudinal lever Rear suspension
			Rear anti-roll bar
			The transverse beam rear suspension
			Repair strut front suspension
			Repair strut rear suspension
		Body
		The air conditioning system
		Electrical equipment

The transverse beam rear suspension

Withdrawal

PERFORMANCE ORDER

1. Raise the rear of the car and fix on support.

2. Remove the wheel.

3. Remove the bolt and the washer that secure the front transverse traction to the crossbar.

4. Remove the bolt and washer securing the rear transverse traction to the crossbar.

5. Remove the nut and remove the hinge bolt of transverse rods to support the rear hub.

6. Remove the two hinge screws on the trailing arm rear suspension.

7. Remove the trailing arm rear suspension.

8. Remove the nuts earrings stabilizer bar.

9. Remove the bolt earring of the stabilizer and remove stabilizer earrings

10. Remove the mounting bracket bolts and bushing stabilizer bracket stabilizer.

11. Remove the stabilizer bar.

12. Remove the three bolts securing the bracket cross-beam, then turn out a bolt of the cross to the cross beam.

13. Remove the crossmember.

Setting

PERFORMANCE ORDER

1. Screw one bolt cross to the cross beam, then screw three bolts of the bracket crossbar. Torque: 46-57 N ??? m
2. Install the stabilizer bar.
3. Lubricate the stabilizer bushing.
	4. Set the stabilizer bushing according to the adjusting labels put on the stabilizer.
5. Establish arms of the stabilizer and fix bolts.
6. Screw the bolt earring of the stabilizer to the cross beam. Torque: 43-61 N ??? m
7. Screw nuts earring of the stabilizer to the stabilizer. Torque: 43-61 N ??? m
8. Install the trailing arm rear suspension bracket and a support hub and fix two bolts. Torque: 43-61 N ??? m
9. Install transverse traction on the support of a nave and fix the pivot bolt, two washers and spring washer, then tighten the lock nut. Torque: 93-117 N ??? m
10. Install the front transverse rod and secure it with a bolt and a lock washer to the cross beam. Torque: 93-117 N ??? m
11. Install the rear transverse rod and secure it with a bolt and a lock washer to the cross beam. Torque: 93-117 N ??? m
12. After the installation, check the angles of the rear wheels.