REPAIR MAINTENANCE OPERATION OF MOTOR VEHICLES
Mazda 323 (1985 release)

general info. full specifications. diagnostics. hints. tips. tricks

Home

Mazda
	323
		Introduction
		Gasoline engines
		Engine oil
		Engine cooling system
		Ignition system
		The power supply system, the carburettor, fuel injection system
		Diesel engine
		Exhaust
		Coupling
		Manual gearbox
			Removing and installing transmission
			The gear change mechanism
			Four wheel drive
		Automatic Transmission
		Suspension and steering system
		Brakes
		Wheels and tires, a body, car coloring, care of the car
		Electrical system
		Heater, illumination system, devices
		Controls and operation receptions
		Electrical diagrams

printable version

The gear change mechanism


1 - shift knob 2 - the center console 3 - side wall 4 - collar shift lever 5 - a bolt and nut 6 - the rubber mounting 7 - a spring 8 - gear lever 9 - the top position of the ball landing 10 - a casing 11 - Holder 12 - lower the landing place of the ball	13 - Sleeve 14 - Rod switch 15 - Self-nut (tightening torque 10 Nm, always be replaced.) 16 - Rubber Seal 17 - a nut and washer 18 - Sleeve 19 - Remote element 20 - extension rod 21 - bolt and nut 22 - Sleeve

Maintenance-free gear change mechanism. It shows a switching mechanism of a vehicle with front wheel drive.

On models with four-wheel drive conventional rod switch replaced two cables. This has the advantage that it requires less space. When the gear there is a difference between the transverse movement (movement of choice) in the idle position and the actual shift. Both movements are transmitted through the corresponding traction gearbox.

Withdrawal

PERFORMANCE ORDER

Raise the vehicle.
Remove the parts in the sequence numbers.

To remove spring -7- remove a hook piece screwdriver.

Setting

PERFORMANCE ORDER

Visually check all the details. Bent rods switch, worn hinges and replace weakened spring.
All joints and bushes before assembly grease the universal lubricant.
Install all parts in reverse order of removal.
Fill the cavity of the support arm switching multi-purpose grease.

Secure the shift rod to the gearbox with the required torque. See section Removing and installing gearbox.

« previos page
Removing and installing transmission

next page »
Four wheel drive